Important - FUXON R-20 Instrucciones De Funcionamiento

Technical facts and references
With 3 LEDs, standlight via capacitor
u
Tested and approved in accordance with
u
the German Road Traffic Licensing Regula-
tions (StVZO)
The reflector surface of the taillight must
u
be oriented vertically to the road and at a
right angle to the longitudinal axis of the
road.
Nominal performance: 0,6 W
u
Input voltage: 6V AC
u
Connecting the rear-light:
Pull the + and – slide-appliance out of the housing (1), insert the designated cables in the
particular port and then push the slide-appliance back into the housing again (2).
1
DC AC 6V 0.6W
Slide
Power cable + Power cable -
Atachment of the rear-light:
Mounting hight: 250-1200 mm
u
Attach the rear light with the designated
u
screws,nuts and washers to the carrier of
the bicycle.
When attaching the tail light, make sure
u
that the screws are tightened so tightly
that the light can not.
3
Screw:
M5 x 15
PLEASE NOTE
If an LED fails, the entire light unit must
be replaced!

Important:

Rear-light and headlamp must only be
switched on at the same time in case they
are run by one alternator.
This rear-light should only be connected to a
frontlight with separate on and off techno-
logy.
2
R-20
REAR LIGHT »R-20«
R-20
DC AC 6V 0.6W
Slide
Power cable + Power cable -
R-20
DC AC 6V 0.6W
Input
vehicle`s longitu-
dinal axis
2 LED red
GB
1 red Main-LED
Before every
journey, en-
sure that the
headlight is
not covered.