Preventative Maintenance; Warranty Notice - Matco Tools EH1500 Instrucciones De Operación

OPERATING INSTRUCTIONS
THIS IS THE SAFETY ALERT SYMBOL USED FOR THE OPERATING INSTRUCTIONS SECTION OF THIS MANUAL
TO ALERT YOU TO POTENTIAL PERSONAL INJURY HAZARDS. OBEY ALL INSTRUCTIONS TO AVOID
POSSIBLE INJURY.
The load leveler is designed to be used with a portable shop crane to handle and position engines and other large vehicle
components. The drive screw adjusts the sling's lift point in relation to the mounting chains to compensate for off-center
loads, or adjusts to a certain angle for component removal or installation.
1. Attach the shop crane's hook or attachment device to the oval link at the top of the sling's lifting block. Make sure
the connection is secure.
2. Lift only on the areas of the engine or component as specified by the vehicle manufacturer. Make sure that all four
chains are securely fastened to the load.
3. Before lifting make sure that all fuel and electrical lines and components are clear of the load.
4. Lift the load just high enough to locate the center of balance or the desired angle in which the load can be removed.
This adjustment is accomplished by turning the sling's drive screw in a clockwise or counterclockwise rotation.

PREVENTATIVE MAINTENANCE

THIS IS THE SAFETY ALERT SYMBOL USED FOR THE PREVENTATIVE MAINTENANCE SECTION OF THIS
MANUAL TO ALERT YOU TO POTENTIAL PERSONAL INJURY HAZARDS. OBEY ALL INSTRUCTIONS TO AVOID
POSSIBLE INJURY.
IMPORTANT: ANY LEVELER FOUND TO BE DEFECTIVE AS A RESULT OF WORN PARTS DUE TO LACK OF
LUBRICATION IS NOT ELIGIBLE FOR WARRANTY CONSIDERATION.
1. Always store the leveler in a well protected area where it will not be exposed to inclement weather, corrosive vapors,
abrasive dust, or any other harmful elements.
2. The leveler must be lubricated periodically in order to prevent premature wearing of parts. A general purpose grease must
be applied to the threads on the screw.
3. Every sling owner is responsible for keeping its label clean and readable.
4. Do not attempt to make any repairs unless you are a qualified repair person that is familiar with this equipment.

WARRANTY NOTICE

Hydraulic Warranty Policy
Matco® shop equipment and tools, excluding accessories, are warranted against defects in materials or workmanship for a
period of 1 year from original purchase. We will repair or replace at our option any defective part or unit which proves to be
defective in material or workmanship within this warranty plan. This warranty does not cover damage to equipment or tools
arising from alteration, abuse or misuse, and does not cover any repairs or replacement made by anyone other than Matco
or its authorized service centers.
The foregoing obligation is Matco Tools sole liability under this or any implied warranty and under no circumstances shall
we be liable for any incidental or consequential damages.
NOTE: Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation
or exclusion may not apply to you.
Return equipment or parts to Matco Tools, or an authorized service center, transportation prepaid. Be certain to include
your name and address, evidence of the purchase date, and description of the suspected defect.
If you have any questions about warranty service, please write to Matco Tools, Stow, OH 44224. This warranty gives you
specific legal rights and you may also have other rights which vary from state to state.
EH1500
EH1500 1500 LBS. ENGINE HANGER
3 03/16/20