Residual Risks - Battipav FORAGRES 070 Manual De Instrucciones

GB

RESIDUAL RISKS

During the design phase, BATTIPAV SRL paid
particular attention to the aspects that may generate
risks for the safety and health of operators.
In spite of this, there are still some potential risks,
which are described below:
CAUTION
• Danger of presence of electric current:
The machine has an internal electric system:
CONNECT THE MACHINE TO A SYSTEM WITH
DIFFERENTIAL PROTECTION AND EFFECTIVE
EARTH WIRE.
CAUTION
• Danger of prolonged exposure to noise:
The continuative use of the machine causes an
exposure to noise levels above 85 dB (A).
OPERATORS MUST
DEFENDERS.
CAUTION
• Danger of exposure
materials. OPERATORS
PROTECTIVE GOGGLES.
CAUTION
• Danger of accidental contact with the moving
tool.
OPERATORS MUST WEAR HEAVY PROTECTIVE
GLOVES.
ALWAYS STAY IN THE WORKING POSITION
(Pos. 1 picture 7) DURING THE MACHINE
OPERATION PHASES:
• During material loading;
• During material cutting;
• During the cutting tool deceleration following the
machine stop.
26
USE PROPER EAR
to fragments
MUST WEAR
MAINTENANCE
CAUTION
BEFORE PERFORMING ANY OPERATION OR
ADJUSTMENT, DISCONNECT THE MACHINE FROM
THE SUPPLY MAINS.
CLEANING
CAUTION
DO NOT WASH THE MACHINE WITH HIGH
PRESSURE WATER JETS
Once the work is completed, remove the machine
from the basin.
• Do not leave the cutter installed after using it.
When the machine is stopped for periods of inactivity,
remove the water from the internal parts by starting
it several times, dry the internal components and
grease the cutter shaft.
of
Should it be necessary to replace the cooling
12
pump, proceed as follows.
• remove the upper protection guard (black colour)
by means of the screw located on the machine
head
• disconnect the pump cables and the hose from
the water distribution unit.
• replace the pump with a new one performing the
opposite operations
CUTTER SHARPENING
13 In order to improve the cutter penetration in the
material, the diamond band must be regularly
sharpened with the appropriate hone provided.
Keep strictly to the following operations.
Put the speed for any cutter diameter.
Position the hone so that the cutter does not
make a complete hole.
• slowly pierce the hone until half its thickness for
around 30/60 seconds.
• repeat this operation at least 3 times.
Battipav srl