Maintenance; Fluid Temperature; Servicing - Waterco Supatuf ECO 100 Manual De Instalación Y Funcionamiento

MAINTENANCE

The strainer basket in the hair and lint pot bowl should be inspected and cleaned at regular intervals.
1. Remove lid and lift out basket.
2. Remove debris and hose off with clean water if necessary.
3. Inspect the lid gasket, lubricate with SILICON based grease only if needed.
If it is damaged replace.
4. Replace the strainer.
5. Re-prime the hair and lint pot bowl.
6. Correctly locate the o-ring.
7. Replace the lid (hand tighten) only.
8. Switch on pump.
In Climates where the pump may be exposed to frost or freezing, care must be taken to ensure the
pump is protected from damage.
It is recommended that if the pump is not used during this winter period it should be drained
completely.
Waterco Limited supply drain plugs for this purpose.
Do not replace the drain plug. Store it in a safe place until you require the use of the pump.
An example would be within the hair and lint pot bowl basket.
If at all possible remove the pump away and store it in a dry location during this period.
When you re activate the pump ensure all seals and o-rings are in operational condition, re-grease if
necessary (replace) if unsure of condition.
• Check that the motor shaft moves freely before re-activation.

FLUID TEMPERATURE

The permissible temperature is > than 0˚C and < than 35˚C. The pump should never be operated
outside of these temperatures or damage may occur.

SERVICING

If the need arises or you are unable to service your Waterco Limited pump always contact your
authorised Waterco Limited Service agent for advise or infield service.
• Always use genuine Waterco Limited replacement parts when carrying out pump maintenance.
Waterco Pumps
I pg 05