Matco PWH3000 Instrucciones De Operación página 4

PWH3000 Auto-Darkening 2 Sensor Shade 10 Welding Helmet
Before using the helmet for welding ensure you have read and understand the safety instructions.
Instructions For Use
• The helmet comes fully assembled. Before starting to weld, adjust the helmet to fit the user properly.
• Adjusting The Fit Of The Helmet
The overall circumference of the headband can be made larger or smaller by rotating the knob on the back of the
headband. ( See adjustment "Y" in fig. 1.) This can be done while wearing the helmet and allows just the right
tension to be set to keep the helmet firmly on the head without it being too tight.
• If the headband is riding too high or too low on your head, adjust the strap which passes over the top of your
head. To do this, release the end of the band by pushing the locking pin out of the hole in the band. Slide the two
portions of the band to a greater or lesser width as required and push the locking pin through the nearest hole.
(See adjustment "W" in fig. 1.)
• Test the fit of the headband by lifting up and closing down the helmet a few times while wearing it. If the
headband moves while tilting, readjust it until it is stable.
• Adjusting Distance Between Helmet And Face
Step 1: Undo the block nut (See"T" in fig. 1) to adjust the distance
between the helmet and your face in the down position. It is important
that your eyes are each the same distance from the lens. Otherwise
the darkening effect may appear uneven.
Step 2: Retighten the block nut when adjustment is complete.
• Adjusting The Viewing Angle Position
Please see fig. 2a and 2b.
fig. 2a
Inside View
PWH3000
"T"
fig. 2b
Outside View
4
"W"
fig. 1
"Y"
08/23/06
"T"