Using For The First Time; Refilling The Water Tank - weasy NVP15 Manual De Usuario

l Make sure the machine is unplugged from the mains.
l Unscrew the safety cap (2) by pushing down and turning anti clockwise.
l Using the graduated funnel (15) fill the machine with up to 1500ml of water. This
should be sufficient to steam clean for approximately one hour.
Once full, replace the safety cap by turning clockwise and fasten tightly.
l
l Attach the accessory on floor cleaning tool when you require to the machine.
l Now plug the machine into the mains and switch on. Two lights should illuminate.
The red light (5) is a power indicator. The orange light (6) indicates that the
machine is building up steam pressure. When the machine is first turned on this
light will illuminate and the machine can take up to 12 minutes to reach the correct
pressure level depending on the amount of water in the tank.
l Once the orange light has gone out the machine is ready to use. The orange light
may come back on when the machine is in use. If this happens, release the safety
trigger and allow the steam pressure to build up once again. This should take no
longer than 40 seconds. If the safety trigger is pressed when the orange light is on
hot water may come out of the machine.
l Switch the machine off using the on/off button(4)
l Disconnect the power cable from the mains. Wait 5 minutes before
l squeezing the safety trigger to make sure that the machine is no longer under
pressure before unscrewing the safety cap. DO NOT unscrew the safety cap until
the steam has stopped.
l Fill the water tank as necessary using the funnel provided.
l DO NOT exceed 1500ml of water before replacing the safety cap by turning
clockwise. Fasten cap tightly.
l You are now ready to switch the machine on and resume steam cleaning.
IF YOU LIVE IN A HARD WATER AREA, IT IS BEST TO USE DISTILLED WATER
(THIS PREVENTS INTERNAL LIME SCALE THAT MAY DAMAGE THE STEAM
SYSTEM)

USING FOR THE FIRST TIME

REFILLING THE WATER TANK