Battipav Prime 500 Manual De Instrucciones página 27

Battipav srl
• Use a mask if working operations are dusty.
Don't abuse cord
• Never carry tool by cord or yank it to disconnect it from socket.
• Keep cord from heat, oil and sharp edges.
Avoid unsteady positions
• Be sure to work in a safe and balanced position.
Maintain tools with care
• Keep tools sharp and clean for better and safer performance.
• Follow all maintenance advice and instructions to replace accessories subject to wear. Inspect tool cords periodically and, if
damaged, have them repaired by an authorised expert. Check extension cords periodically and replace them if damaged. Keep
handles dry, clean and free from oil and grease.
Disconnect tools
• When not in use, before servicing, and when changing accessories subject to wear.
Remove service keys from tool
• Form the habit of checking to see that keys and adjusting wrenches are removed from tool before turning it on.
Avoid unintentional starting
• Be sure that the switch is off when plugging in the tool.
Extension cords for outdoor works
• When tool is used outdoors, use only extension cords intended for this particular use and so marked.
Stay alert
• Watch what you are doing. Use common sense. Do not operate tool when you are inattentive.
Check tool for damaged parts
• Before further use of the tool, check it and the safety devices for damages and be sure that they operate properly. Check for
functioning and binding of moving parts, breakage of parts, correct mounting, and any other conditions that may affect the
correct operation of the tool.
• Damaged safety devices or other parts should be properly repaired or replaced by an authorised Service Centre unless
otherwise indicated elsewhere in this instruction manual.
• Have defective switches replaced by an authorised Service Centre.
• Do not use tool if its switch cannot be turned on or off.
Warning
• For your personal safety use only accessories recommended in this instruction manual or in the relevant catalogues The use
of any other accessory or attachment other than those recommended in this instruction manual or in the relevant catalogue
may present a risk of personal injury.
Have tools repaired by qualified personnel
• This electric appliance is in accordance with the safety rules in force. Only qualified experts may carry out repairing of electric
appliances otherwise it may cause considerable danger for the user.
*
1
The noise level emitted by the machine was measured in accordance with the UNI EN12418, EN3744 standards. Measurements
were performed in the absence of load and at maximum speed using a cutting tool with a diameter of 600mm.
*
2
The machine in working conditions has a noise emission higher than 85 dB (A).
The vibration level transmitted to the hand-arm system was measured in accordance with the UNI EN ISO 5349-1 standard
SRS ART. 90XXXZ
The machine in equipped with a phase check SRS that activates an acustic signal when the phase is opposite to the direction of
rotation of the diamond disk.
THE SRS is DESIGNED SOLELY FOR USE ON BATTIPAV MASONRY SAWS MODELS: PRIME 500/650/700 AND
EXPERT 500/600/700. THE MANUFACTURER DISCLAIMS ANY LIABILITY FOR THE USE OF THE SRS IN OTHER
APPLICATIONS THAN THOSE SHOWN.
In the case of acoustic signals:
32
1. Disconnect the power cord from the machine
33
2. Rotate the two phase switch inside the plug by using a screwdriver.
3. WAIT 30-60 SEC. IN ORDER TO LET THE SYSTEM reset
4. Reconnect the power cord to the machine.
• To avoid false alarms, connect and disconnect the power cord several times before inverting the phases.
• Check the proper functioning of the system without tools before starting the machine for the first time, in
order to get familiar with the procedures of use.
•
Always ensure the correct rotation of the blade before use.
GB
27