Auxiliary Handle Assembly; Start Up - PRETUL ESMA-4-1/2P2 Manual De Instrucciones

Assembly

Auxiliary handle assembly

• For a safe operation use the auxiliary handle. Fit
the auxiliary handle onto one of the two mounting
orifices to make the job easier.

Start Up

The angle grinder is a manual power tool. It is used to grind and cut steel, pipes, angled iron, bricks, tiles stone and/or
ceramic pieces. To remove burr from metal surfaces, to level and to smooth down solder. If changing the tool accessory it
can be used to clean oxide and to polish metal surfaces or other type or materials.
Turning On
• Connect the plug to the power outlet.
• Press the switch rear side and push it forwards to start the
grinder.
• For continuous operation push the switch until it stops in the
tool's housing notch (C).
• To stop using it, press the rear side of the switch. It will get
released and turn back to the off position stopping the tool motor.
How to adequately hold the tool
Always hold the tool with both hands. One hand holds the
handle and the other hand holds the auxiliary handle. Use
care not to obstruct the vent slots.
• Grinding:
To get better results hold the tool 15° to 30° regarding the
work piece. Make forward-backward movement applying a
slight pressure with a steady rhythm. The work piece will not
get too hot and will not have any discoloration. Also no
rough edged will be produced.
• Cutting:
Do not press, tilt or oscillate the tool. Work with steady
speed. The disc shall turn always in a counter wise direction
regarding the cutting movement. Never in a different
direction, otherwise the tool will shoot out uncontrolled.
To cut hard stones is advisable using a diamond-cutting disc.
Useful Tips
• Work with the disc in the right position to prevent damaging it.
• Press on the work piece using less pressure than the tool weight to prevent overload damaging
the motor or the disc.
• After installing a new disc allow it to turn idle at least one minute. If the disc vibrates, replace
immediately.
• Avoid working with soft wood or metal such as lead. These materials saturate
CAUTION
the disc very quickly and damage it.
Start
C
Switch
ENGLISH
Stops
7