Installation; Before Using Your Refrigerator; Indicator Of Temperature - Sharp SJ-SC680V Manual De Manejo

INSTALLATION

WARNING
■ Do not install the refrigerator in a damp or wet
location as this may cause damage to the insulation
and a leakage . Condensation may also build on the
outer cabinet and cause rust .
1
Keep adequate ventilation space around the refrigerator.
• The figure shows the minimum
required space for installing the
refrigerator. The measurement
condition of power
consumption is conducted
under a different space
dimension.
• By keeping greater space, the
refrigerator may be operated
under a less amount of power
consumption.
• If using the refrigerator in the smaller space
dimension than the below figure, it may cause the
temperature rise in the unit, loud noise and failure.
• The space between the rear of the refrigerator and
the wall should be 60mm or more and less than
75mm.
If the space is wider than 75mm, you may get injured
by touching compressor and its peripheral parts
which are extremely hot during the operation.
Overall space
required in use

INDICATOR OF TEMPERATURE

This refrigerator is provided with an indicator of temperature in the refrigerator compartment to allow you to control the average
temperature in the coldest zone.
Coldest zone
The symbol indicates the coldest zone in the
refrigerator compartment.
(The door pocket positioned at the same height
isn't the coldest zone.)
Checking the temperature in the coldest zone
You can carry out regular checks to ensure the temperature
in the coldest zone is correct and, if necessary, adjust the
refrigerator temp. control.
To maintain a correct temperature inside the appliance,
check that the indicator of temperature is always BLUE.
If the indicator of temperature turns WHITE, the temperature
is too high; in this case, increase the refrigerator temp.
control setting and wait for 6 hours before checking the
indicator of temperature again.
90mm
or more
60mm
or more
60mm
or more
1400 mm
Symbol
2
Use the two front adjustable feet, to ensure that the
refrigerator is positioned firmly and flat on the floor.
3
Remove the 2 screws of the cabinet lower part, and
then set the foot cover (supplied inside the refrigerator
compartment) with removed 2 screws.
NOTE
• Position your refrigerator so that the plug is accessible.
• Keep your refrigerator out of direct sunlight.
• Do not place next to heat generating appliance.
• Do not place directly on the ground. Provide suitable stand.
When transporting
• The casters allow the refrigerator to move back and forth.
• Carry the refrigerator by holding the handles located on the
rear and the bottom.
rear
Casters (4 pcs .)

Before using your refrigerator

Clean the inside parts with a cloth soaked in warm water.
If soapy water is used, wipe it off thoroughly with water.
BLUE
Correct setting
NOTE
• The internal temperature of the refrigerator depends on
various factors such as the ambient temperature of the room,
the amount of food stored and the frequency of door opening.
• When fresh food has been introduced or the door has been
left open for some time, it is normal for the indicator of
temperature to turn WHITE.
Free standing type
Adjustable foot
Foot cover
Screw (2 screws)
bottom
WHITE
Temperature too high,
adjust the refrigerator temp.
control.
5