Troubleshooting - H.Koenig STM10 Manual De Utilización

leakage.
Tip: emptying the tank after each use is recommended because
standing water can leave a residue over time.
STEAMING TIPS AND TRICKS
▪ This steamer is designed to use distilled , purified , or filtered water . Tap water contains minerals that
build up. Using water with perfumes or scented additives is also not recommended.
▪ Always test garments by steaming a small hidden area to make sure the garment takes well to steam.
▪ Always read garment care label instructions . Low heat settings require the delicate fabric frame.
▪ Small amounts of dripping might occur during use . If excessive, either the steamer needs time to get back
up to full temperature. Just allow the steamer a minute to reheat.
▪Wearing clothes immediately after ironing or steaming can actually create wrinkles . Always allow clothing
to cool for about 5 minutes after ironing or steaming to set the press.

TROUBLESHOOTING

Problem
The steamer is plugged in
but not heating.
Not enough steam or no
steam is coming out of the
steamer.
Discolored water is coming
through the holes and
staining the fabric.
Steamer is leaking or
spitting.
Possible Cause
There's a power supply issue.
The auto shut-off has activated.
The steamer isn't heated up to
full temperature.
There is not enough water in the
water tank.
The water pump hasn't been
primed.
Residue has built up in the
water tank or on the plate.
Perfumed or scented additives
were used.
Steamer is not hot enough.
Water tank is running low.
Solution
Check that the plug is properly
inserted into the outlet or try
plugging the steamer into a different
outlet.
Press the steam trigger or press the
power button to activate the
steamer.
Always allow steamer to preheat at
least 35 seconds, or until the power
button light is a steady blue.
Follow the instructions under the
"filling the water tank" section and
fill to MAX level marker.
After preheating, always prime the
water pump by holding the steam
trigger until steam forms to ensure
enough water is in the boiler.
Empty the water tank after each use.
Only use distilled, filtered, or
purified water.
Regularly clean steamer and refrain
from using perfumed or scented
additives.
Allow the steamer to heat for
about35 seconds.
Follow the instructions under the
"Filling the Water Tank" section and
fill to Max level marker.