Operation - Greenlee HKL1232 Manual De Instrucciones

Operation

Electric shock hazard:
This tool is not insulated. When
using this unit on or near energized
electrical lines, use proper personal
protective equipment.
Failure to observe this warning could
result in severe injury or death.
Wear eye protection when operating
or servicing this tool.
Failure to wear eye protection could
result in serious eye injury from flying
debris or hydraulic oil.
Skin injection hazard:
• Do not use hands to check for
leaks.
• Depressurize the hydraulic system
before servicing.
Oil under pressure easily punc-
tures skin, causing serious injury,
g angrene, or death. If you are injured
by escaping oil, seek medical atten-
tion immediately.
Keep hands away from the crimping
tool head when crimping.
Failure to observe this warning could
result in severe injury or death.
An incomplete crimp can cause a fire.
• Use proper die, connector, and cable combina-
tions. Improper combinations can result in an
incomplete crimp.
• The handle load will drop suddenly to indicate
a completed crimp. If the handle load does not
drop suddenly, the crimp is not complete.
Failure to observe these warnings could result in
severe injury or death.
Greenlee / A Textron Company
HKL1232 Hydraulic Crimping Tool
1. Clean the die seat area.
2. Install the proper size and type of crimping dies.
Refer to the Greenlee catalog for the crimping dies
available from Greenlee.
3. Pull the die release knob on the crimping head and
slide one of the die halves into the jaw. Release the
knob and slide the die half until the retainer snaps
and locks the die into place.
4. Press the die release button on the ram body
(located in the cutout) and slide the other die half
in. Release the button and slide the die half until the
retainer snaps and locks the die into place.
Pull
5. Follow the connector manufacturer's instructions
for appropriate cable strip length and surface
preparation.
6. Insert cable fully into the connector and center the
connector between the dies.
6
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
Press
Insert dies