Matco Tools MT3883 Instrucciones De Operación página 3

FEATURES
• Super high performance, industrial grade 1HP motor for extra torque and extended durability
• The most powerful die grinders on the market
• Positive stop regulator for more versatile performance on all kinds of jobs
• Super comfortable safety throttle lever to prevent accidental start ups
• Adjustable rear exhaust to direct air away from the work and away from the user
• 90˚ angle head for work in limited access areas
• Heavy duty industrial cut gears for extra long life and quiet performance
OPERATION
Always turn off the air supply, drain hose of air pressure and detach tool from air
supply before installing, removing or adjusting any part or accessory on this tool,
or before performing any maintenance on this tool.
Bonded abrasive mounted point grinding wheels, rotary files and carbide burrs can
be mounted providing their speed rating exceeds the speed of the Die Grinder. The
shank size of the mounted accessory must match the collet size fitted in the Die
Grinder. Insert the shank of the mounted point as far as possible into the collet and
tighten the nut using the supplied wrenches. Minimum shank gripping length must
be 10mm.
After mounting a new point, start the Die Grinder under bench and run for a few
seconds. If the Die Grinder starts to vibrate when first fitting a mounted point or
during operation, immediately remove from service. If Die Grinder is dropped,
replace bonded abrasive mounted point grinding wheel, rotary file or carbide burr.
When using the Die Grinder, be careful not to exert excessive force which could be
hazardous and cause mounted spindle to bend or break.
NOTE: During operation, safety goggles should always be worn to guard against
flying rust and chips (users and bystanders).
MT3883
MT3883 1 HP Right Angle Die Grinder
3
rev. 05/25/16