wolfcraft master 700 Traducción Del Manual De Instrucciones Original página 24

INTRODUCTION
• CAUTION! Read all the safety information and instructions that were supplied with the MASTER 700 and the power tools used.
Failure to comply with safety information and instructions can lead to electric shock, fire and/or serious injury.
• Keep the manual in a safe place for future reference.
TECHNICAL DATA
Dimensions when fully assembled:
Dimensions when folded up:
Tilt of table surface:
Clamping area between clamping jaws:
Bore diameter of clamping bores:
Maximum load:
Weight:
SYMBOLS AND MEANINGS
Warning of general danger
Read instructions/information.
Wear safety goggles.
Wear ear protection.
Wear a dust mask.
Pull out mains plug
ASSEMBLY TOOL
2 Allen keys: SW 4
(included in scope of delivery)
INTENDED USE
The MASTER 700 is a height-adjustable clamping and working table.
• It is suitable for use as a working table for machining workpieces (e.g. drilling, sanding, etc.).
• The working table allows workpieces to be clamped between the clamping jaws.
• The additional clamping boards allow larger workpieces to be clamped.
• The height of the working table can be adjusted between 780 and 950 mm and the tilt of the table top can be varied between 0° and max. 70°.
• Mitre saws or drill stands may only be mounted on the working table using the fastening screws supplied.
CAUTION: It is only possible to use machines on which the workpiece is processed vertically from top to bottom.
CAUTION: Machines that apply lateral pressure to the working table should not be mounted.
• Observe the manufacturer's safety instructions for the machines used, as well as the safety instructions for the working table.
• When disposing of the MASTER 700, please observe local disposal regulations.
The user is liable for any damage or accidents resulting from improper use.
SAFETY INFORMATION
• MAssemble the working table correctly and check that all the handle screws and screw joints are tight before starting to work. Correct assembly
ensures that the table does not fold up and the table plate does not tilt unintentionally.
• Never use your working table improperly or for an unintended purpose!
• Remove all items that are surplus to requirements from the working table.
• Make sure that your hands do not get caught in the folding, sliding or tilting parts of the working table. Risk of injury!
• Never work with a defective working table!
• Clamp the workpiece to be processed firmly!
• Make sure that all screws and handle screws are tight during transport.
• Place the working table on a firm, level and horizontal surface. If the working table can slip or wobble, the workpiece or power tool cannot
be controlled evenly and safely.
• Make sure that both eccentric levers are always tightened so that the height of the table cannot change.
• Assemble the working table correctly before mounting the power tool.
• Fasten the power tool securely on the working table before using it. If the power tool slips on the working table, this can lead to loss of control.
t
680 x 585 x 780 - 950 mm (width x depth x height)
680 x 180 x 950 mm
0° - max. 70°
max. 130 mm
20.2 mm
150 kg
14.8 kg
General information
Do not apply weight unevenly.
Maximum load: 150 kg
Do not use as a seat, ladder or support.
Do not stand on the working table.
1 screwdriver: PH 2
(not included in scope of delivery)
24
2 hexagonal key: SW 10, 13
(not included in scope of delivery)