Akasa all in one 2 Instrucciones De Instalación página 4

2. Installing the panel inside a case
 Remove the cover of an empty 5.5" external drive bay.
 Insert all cables into the empty drive bay. Push the allinone
into the bay until it is flush with the chassis front panel
3 Secure the allinone with screws or the case 5.5" mounting system
5
3. Connecting the fans and temperature sensors
 Connect the fan connector to the allinone fan cable.
Connect the other end of the fan cable to the fan header on the
motherboard (optional).
 Connect temperature sensors to the allinone sensor cable. Use the
adhesive tape to secure them in the appropriate location.
NOTE : In auto mode Fan, and 3 are controlled by Sensor , and 3
respectively. Please locate the sensors in the appropriate position.
WARNING: Do not place the sensor between the heatsink base
and the CPU.
3 Connect the power cable to the PSU 4-pin molex connector.
6