Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
In case the units is not being used, please always turn the device off using
the power button.
TO AVOID THE RISK OF SUFFOCATION, IT'S ESSENTIAL TO MAKE SURE
THE BABY CAN NEVER REACH THE ADAPTOR CABLE.
tact
unit
MAINTENANCE
Only clean the baby monitor with a moist cloth; never use chemical cleaners.
baby
Before any cleaning, you must disconnect the adapters. Before cleaning, any
hing
connected power adaptors must be disconnected.
ved,
PROBLEMS – REPAIR WORK
eep
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
start
are designed to provide reasonable protection against harmful interference
oon
in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
the
installation. If this equipment does cause harmful interference to radio or
ones
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
15s
No power on indicator
it or
light
get
Green LEDs lit:
n
no sound transmission
Reception too poor,
interference
PS
ning
Whistling
and
e.
erve
unds
hat's
om.
, an
e Mini call 2017 USA v7.indd 7
• Reorient or relocate the receiving antenna
• Increase
the
separation
equipment and receiver
• Connect the equipment into an outlet on
a circuit different from that to which the
receiver is connected
• Consult the dealer or an experienced radio/
TV technician for help
• Check the adapter connections
• Check the state of the batteries
• Press Power button for 3s
• Check the position of the volume
• Check the state of the batteries
• Check the state of the batteries
• Bring the units close together
• Increase the volume
• Move the receiver away from any working
electrical appliances
• Reduce the volume
• Move the receiver away from the transmitter
7
between
the
04/04/2017 09
Publicidad
Tabla de contenido
