Shark DUOClean Powered Lift-Away NV830 Serie Instrucciones página 23

Vacuum turns off on its own or Brushroll Indicator Light flashes red.
•
This vacuum is equipped with a motor-protective thermostat. If your vacuum overheats, the
thermostat will automatically turn the suction motor off. Perform the following steps to reset
the thermostat:
1. Turn vacuum off and unplug it.
2. Empty dust cup and clean filters (see Maintenance section).
3. Check for blockages in hose, accessories, and inlet openings.
4. Allow unit to cool for a minimum of 45 minutes.
5. Plug in vacuum and turn it on.
•
If hose is not fully connected to the pod, it can cause a poor electrical connection and the
hose can come loose, turning the vacuum off.
1. Turn vacuum off and unplug it.
2. Empty dust cup and clean filters.
3. Check for blockages in hose, accessories, and inlet openings.
4. Remove cord from cord hook so hose latch can be seen and engaged.
5. Ensure that hose, wand, and handle are all clicked securely into place at all connection points:
a. Where hose meets back of pod (may require additional force; pull on hose to ensure
latch is fully engaged)
b. Where wand plugs into floor nozzle
c. Where handle plugs into wand
6. Plug in vacuum and turn it on.
Note: If vacuum still does not run properly, contact Customer Service at 1-800-798-7398.
s h a r kc l e a n . c o m
22