Specifications; Important Hints; Used Symbols; Installation - Hameg Mainframe HM8001-2 Manual Del Usuario

TECHNISCHE DATEN TECHNISCHE DATEN

SPECIFICATIONS

Referenztemperatur: 23 °C ±2 °C Referenztemperatur: 23 °C ±2 °C
Valid at 23 degrees C after a 30 minute warm-up
period
General
Mainframe with power supply accomodates any 2
modules. 4 BNC connectors on rear panel for external
interconnection to each module compartment (Option
HO801)
Module Supply Voltages
2 x 8 V
AC
2 x 5 V
DC
4 x 20 V
DC
Voltages
Polarity:
Power consumption per module:
All DC voltages are electronicaly stabilized, floating and
short circuit proof.
AC test voltage to chassis: 500 V
Miscellaneous
Power switch on front panel between the two modules.
Line voltage:
Power consumption:
Protective system:
Size (W x H x D):
Weight:
Color:
Included in delivery:
Maineframe HM8001-2, Operator's manual
Optional Accessories:
HO801 BNC connectors
max. 0.5 A each
max. 1 A each
max. 0.5 A each
between 5 V and 20 V are
programmable from each
module
optional
max. 25 Watt
115/230 V at 50 - 60 Hz
max. 110 Watt
Safety class I (EN61010-1)
285 x 75 x 365 mm
approx. 4 kg
techno-brown
S p e c i f i c a t i o n s

Important hints

The operator is requested to carefully read the
following instructions and those of the mainframe
HM8001-2, to avoid any
operating errors and
mis-takes and in order to
become aquainted with the
module.
After unpacking the module, check for any
mechanical damage or loose parts inside. Should
there be any transportation damage, inform the
supplier immediately and do not put the module
into operation. This plug-in module is primarily
intended for use in conjunction with the Main-
frame HM8001-2. When incorporating it into other
systems, the module should only be operated with
the specified supply voltages.

Used Symbols

ATTENTION refer to manual.
DANGER High voltage.
Protective ground (earth) terminal.

Installation

If the HM8001-2 is to be stacked with other
mainframes or HAMEG Oscilloscopes, the exact
positioning is only ensured by the footrests
delivered with the instrument. These should be
attached to the top of each instrument (except
the uppermost one) using the double-sided
adhesive tape provided. Insert the footrests into
the appropriate ventilation holes on top of the
lower instrument in such a way that they
correspond exactly with the positioning of the feet
on the instrument to be stacked above. Instru-
ments stacked in a tilted position will now be
prevented from slipping. Put the undermost
Subject to change without notice
TRIPLE POWER SUPPLY HM 8040-3
FUSE
FUSE
ON/OFF ON/OFF
OUTPUT
HAMEG
PUSH LONG
VOLTAGE CURRENT VOLTAGE CURRENT
15