3M Digital Board Guía De Seguridad Del Producto página 8

Installation
3. Using a Phillips screw driver, screw the supplied
anchors into the wall until they are flush with the
wall surface using one for each identified hole
location.
. Align the wall bracket holes over the wall anchors
and secure with the provided washer and anchor
screws. Confirm that the wall bracket is level
before tightening the screws.
Note: For other types of wall material (e.g. wood,
concrete, concrete block) use mounting hardware
that is properly rated for the weight of the unit and is
intended for specific wall material.
Hanging on the Wall
1. If possible, position the 3M Digital Board and
pen tray in front of the wall where the bracket
is located. Position the unit on the floor on its
backside so that the top is closest to the wall.
. Clear the path from the unit to the wall where it
will be hanging.
To reduce the risk associated with muscle strain:
• Always use more than one person when installing or removing the 3M Digital Board
3. With one person holding each side of the unit,
carefully lift it into position so that the bracket slot
is above the wall hanger bracket and then lower
into mating position onto wall hanger bracket.
Ensure that the unit is securely in place before
releasing.
8
WARNING
© 3M 006. All Rights Reserved.
3M™ Digital Board