Specifications; Legal Notices - Insignia NS-LCD22 Guia Del Usuario

NS-LCD22.fm Page 20 Monday, February 19, 2007 1:39 PM
Category Problem Possible Solution
Television
cabinet creaks
Control buttons
do not operate
Caution
Never attempt to repair a defective television
yourself.
Note
If your problem is not solved, turn your television
off and then on again.

Specifications

Note
• Design and specifications are subject to
change without notice.
• Weight and dimensions shown are
approximate.
• Specifications and external appearance may
be changed for the sake of improvement.
Type LCD TV
Panel 22-inch TFT LCD
TV system American TV standard ATSC/NTSC system
Receiving channels VHF 2-13, UHF 14-69, CATV 1-125, CADTV
1-135, DTV 2-69
Audio multiplex BTSC system
Audio out 4W x 2
Power requirement AC 100-240 V. 50/60 Hz
Power 60 W
consumption
Dimensions 23.2 x 19.2 x 7.1-inches
(589 x 487 x 180 mm)
Weight 24 lbs/11 kg
Input terminals 1 Composite Video/Audio (L/R)
1 S-video
1 Component Video/Audio (L/R)
1 HDMI interface
1 VGA/Audio
1 Antenna
Output terminals 1 Composite Video/Audio (L/R)
1 headphone jack
Control terminals 1 RS-232
20
• When the television is in use,
there is a natural rise in
temperature, causing the
cabinet to expand or contract
and may be accompanied by
a slight creaking noise. This
is not a malfunction.
• Disconnect the power cord
and wait for a few seconds.
Then re-connect the power
cord and turn on the
television again.
www.insignia-products.com
Insignia NS-LCD22 LCD TV

Legal notices

FCC Part 15
This device complies with Part 15 of the FCC Rules.
Operation of this product is subject to the following two
conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference
received, including interference that may cause undesired
operation.
This equipment has been tested and found to comply within
the limits for a class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more
of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
• Consult the dealer or an experienced technician for
help.
FCC warning
Changes or modifications not expressly approved by the
party responsible for compliance with the FCC Rules could
void the user's authority to operate this equipment.
DHHS and FDA safety certification
This product is made and tested to meet safety standards of
the FCC, requirements and compliance with safety
performance of the U.S. Department of Health and Human
Services, and also with FDA Radiation Performance
Standards 21 CFR Subchapter J.
Canada ICES-003 statement
This Class B digital apparatus complies with Canadian
ICES-003.
RSS 310 statement
To reduce potential radio interference to other users, the
antenna type and its gain should be so chosen that the
equivalent isotropically radiated power (e.i.r.p.) is not more
than that permitted for successful communication.
Copyright
© 2007 Insignia. Insignia and the Insignia logo are
trademarks of Best Buy Enterprise Services, Inc. Other
brands and product names are trademarks or registered
trademarks of their respective holders. Specifications and
features are subject to change without notice or obligation.
For service and support call (877) 467-4289.