5.- OPERATION:
Before using this transceiver, please check it has been programmed on the
correct frequency band and operating mode allowed by the regulations valid in the
EU Member State where it will be used. If not, please change the frequency band
(see section 5.11 of this manual).
NOTE: This transceiver can be factory pre-programmed on a frequency band not
allowed in the country of use.
5.1.- POWER ON/OFF THE TRANSCEIVER:
(1) Turn [ON/OFF/VOL] knob clockwise to power ON the transceiver, the LCD displays
the Multistandard mode and then displays channel number.
(2) Turn [ON/OFF/VOL] control anti-clockwise, until hear "click", to turn OFF the
transceiver.
NOTE:
- This transceiver support 12VDC power supply. Optional version support
12/24VDC. Check your CB version before connect the power supply.
5.2.- VOLUME CONTROL:
Turn [ON/OFF/VOL] clockwise to increase volume and anti-clockwise to decrease volume.
5.3.- CHANNEL CONTROL:
(1) Short press [UP] / [DOWN] key to change channel by one step.
(2) Hold [UP] / [DOWN] key can fast changed channel.
5.4.- [SQ/AQ] KEY:
Squelch level (short press):
(1) Short press [SQ/AQ] key, until LCD displays "SQL.SET 08", "08" stands for squelch
level, the bigger value stands for high squelch level.
(2) Short press microphone [UP] or [DOWN] key to change SQ/AQ level.
(3) Long press microphone [UP] or [DOWN] key can fast change SQ/AQ level.
(4) Short press [SQ/AQ] key or wait for 10 seconds to store and exit.
NOTE:
- The higher SQ level selected, the stronger signal required to open speaker and
hear the calling.
ASQ control (long press):
(1) Long press [SQ] key, until LCD displays "AQ", the ASQ function turned on.
(2) Short press [SQ] key, until LCD displays "ASQ.SET 06", "06" stands for ASQ level,
the bigger value stands for high squelch level.
(3) Short press [UP] / [DOWN] key to change ASQ level.
(4) Hold the microphone [UP] / [DOWN] key can fast change ASQ level.
NOTICE!
English - 6 -