Dell PowerVault MD3600i Guia De Inicio Rapido página 21

LED Indicators (continued)
RAID controller module
Switch
System identification button
Enclosure mode switch
Password reset switch
Power Supplies
AC power supply (per power supply)
Wattage
Voltage
Heat dissipation
Maximum inrush current
Eight single-color LEDs:
• One battery fault
• One cache active
• One controller fault
• One controller power
• One system identification
• One management Ethernet activity
• Two iSCSI IN port activity
Four two-color LEDs:
• Two iSCSI IN link speed
• One SAS OUT link or fault
• One management Ethernet link speed
Located on the front control panel.
This button is used to locate a system
within a rack.
Located on the front of the system.
This switch is not applicable to the
PowerVault MD3600i series storage array.
Located on the back panel of the RAID
controller module. This switch is used to
reset the storage array password.
600 W
100–240 VAC (8.6 A–4.3 A)
100 W
Under typical line conditions and over the
entire system ambient operating range,
the inrush current may reach a maximum of
55 A per power supply for 10 ms or less.
Getting Started With Your System
19