Preparation For Use - lauson Audio CP441 Manual De Instrucciones

PREPARATION FOR USE

Unpacking and Setup
* Carefully remove the unit from the display carton and remove all packing material from
the unit itself.
* Remove any descriptive labels that may be found on either the front or top cabinet of the unit.
Do not remove any labels located on either the back or button cabinet of the unit.
Power Sources
Using AC Power
Connect the AC power into Standard household wall outlet.
Power Supply
Using AC power
1.check if the power voltage, as shown on the type plate located on the bottom of the set,
corresponds to your local ac power supply if it does not consult your dealer or service center.
2.connect the power cord to the ac mains inlet and the wall outlet. the power supply is now
connected and ready for use.
3.to switch off completely, unplug the power cord from the wall outlet.
unplug the power cord from the wall outlet to protect your set during heavy thunderstorms.
Batteries for the unit (not included)
Open the battery compartment and insert six batteries, type LR14, UM-2 or C-cells,
(preferably Alkaline) with the correct polarity as indicated by the " + " and " - " symbols
inside the compartment.
Batteries contains chemical substances, so they should be disposed of properly.
Incorrect use of batteries can cause electrolyte leakage and will corrode the compartment
or cause the batteries to burst. Therefore:
Do not mix battery types: e.g. alkaline with carbon Zinc. Only use batteries of the same
type for the set.
When inserting new batteries, do not try to mix old batteries with new ones.
Remove the batteries if the set is not be used for a long time.
EN-2