Before Starting - MWM Phase Serie Manual Del Usuario

Quick Start Guide
For the latest information about Phase, product registration, or additional support
visit mwm-store.com/support
Phase Remote
Dock A
Remotes
battery
indicators
USB Port
2
Phase Receiver
Dock B
Status LED
Output Channels A & B

Before starting

Follow these steps carefully to make sure you
get the best experience with your Phase.
Configuration
Download the Phase configuration software
on mwm-store.com/configuration and install it
on your computer.
Plug the Phase Receiver to your computer
using the USB Cable provided in the box, and
Setup
launch the configuration software. Make sure
buttons the Remotes are placed on the Receiver
A & B when connecting it to your computer.
Connect to your MWM account (the one you
used to buy your Phase on mwm-store.com).
Or if you don't have one, please create it to
register your product.
Follow the steps indicated on the configuration
software and install the available update to
access the latest firmware version of Phase.
Charge
Put the Remotes on the Receiver. They will
automatically charge when the Receiver is
connected to a power source (computer,
power outlet...).
Note: If you're using Phase for the first time, we
recommend you to fully charge the Remotes before
using them. You will need around two hours to
completely charge your Remotes.
Setup
Connect Phase to your DVS interface
The Receiver needs to be connected to a power
source (computer, power outlet...) to be used.
Connect the output channels of the Receiver
to the line inputs of your DVS interface (either
external sound card or integrated DVS mixer)
using the RCA Cables provided in the box.
Note: Depending on your setup you might have to
manually switch the inputs to line/cd mode on your DVS
interface/mixer.
Prepare your record
Take one of the magnetic stickers provided in
the box and remove the protective band under
the sticker.
Place your record on the turntable, align the
sticker hole with your turntable spindle and
place the sticker on your record.
Note: Be careful, stickers can be difficult to remove from
your records.
Activate the Remotes
Take the Remotes out of the Receiver and place
them on your record on the magnetic stickers.
Don't move the Remotes until the LED strip
is completely filled up. Remotes are now
calibrated and ready to use.
Make sure your DJ software is set on relative
mode for Phase to work properly.
Note: By default Phase is optimized to work with Serato DJ
software©, if you are using a different DJ software you will
need to set it from the Phase configuration software.
You are all set and you can
now use Phase!
3