Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Section 4: Operation
11. Start engine according to instructions given in engine
owner's manual. Also see operating instructions tag
located on the pressure washer.
CAUTION
Avoid injury from kickback.
• When starting engine, pull cord slowly until resistance is felt
and then pull rapidly to avoid kickback.
• If engine starts and fails to continue to run or if increased
resistance is felt during starting pull attempts, squeeze trigger
on spray gun.
How to Stop Your Pressure Washer
• Move variable pressure control lever to "Stop" position.
• Turn engine off according to instructions given in the
engine owner's manual.
• Squeeze trigger on the spray gun to relieve
pressure in the hose.
NOTE: A small amount of water will squirt out when you
release the pressure.
How to Use Accessory Tray
The unit is equipped with an accessory tray with places to
store your nozzle extension , and slots to hold the cleaning
solution bottle and the detergent siphoning filter.There are
also two hooks at the ends of the handle to hold your
spray gun and high pressure hose.
NOTE: The extra holes in the tray are for storing a brush
and a turbo wand.The brush and turbo wand are NOT
included with your pressure washer.You can buy these
items as optional accessories.
1.
Place nozzle extension through hole on accessory tray,
as shown in Figure 14.
Figure 14 — Typical Accessory Tray
2.
Hang chemical solution bottle on "J" hook and place
detergent siphoning filter in last slot on left (Figure 14).
3.
Place spray gun on hook attached to accessory tray on
right side of unit (Figure 14).
4.
Hang high pressure hose on hook attached to
accessory tray on left side of unit as shown on page 5.
10
Publicidad
Tabla de contenido
