Vision TECHCONNECT CONTROL El Manual Del Propietario página 9

ADVANCED MODE PROGRAMMING
NOTE: Device must use mains-power for these advanced functions.
Use when you need to
Program multiple codes to each button
•
Use RS-232 or 12v trigger
•
• Add an extension keypad
Program scheduled actions
•
• Duplicate to multiple devices
1. LOAD SOFTWARE ONTO PC Download from Vision's website:
www.visionaudiovisual.com/techconnect/tc3-ctl
2. CONNECT CONTROL MODULE VIA USB In the battery compartment there is a standard
USB-B mini connector. (USB cable not included)
The software can be used without a control module connected, but if learning IR codes you
will need to connect a control module.
3. LAUNCH SOFTWARE You can create a new program, edit program saved on PC, or edit
program saved on device.
To find firmware version of your device click "Read CTL3
Time"
9
TC3-CTL_manual_en.doc