Publicidad
Idiomas disponibles
Idiomas disponibles
Setting the Language
Programming
PROG
Pump Functions
-
Max flow rate
P100%
-
Alarm Relay
N.Open
-
Language
English
-
Paragraph 1 – Manual Dosage
Programming
PROG
Configuration
Pump Funtions
-
+
Pump
Functions
Display during Operation
Operating mode
Man = Manual
Alarms and statuses
Lev = Level alarm
Flw = Flow alarms
Paragraph 2 - Dosage Proportional to Signal 0/4-20
Programming
PROG
Configuration
Pump Funtions
-
+
Pump
Functions
0/4 - 20 mA
0/4 - 20 mA
Low
4.0mA
-
0/4 - 20 mA
High
20.0mA
-
EM00136061
-
+
-
The pump operates in constant mode. The flow can only be manually
regulated by pressing the
the flow, or the
FLOW sensor
status
MAN
F F
F
Lev
Stop
P100%
Pump status
Empty = pump in start
Stop = pump stationary
Paus = pump in pause
The pump proportionally doses at a signal of (0)4-20 mA. On the basis of
the factory settings, the pump interrupts dosage at 4mA and doses at the
maximum set frequency when it receives 20 mA. These two values can be
modified during programming. The maximum frequency can be modified
during operation, by pressing the
-
+
-
+
Makes it possible to select the language. The pump is set in
English in the factory.
Changes can be made by pressing the
using the
confirm and return to the main menu
Current dosage speed
(depends on selected unit of
measurement)
Percentage, Frequency,
l/h, Gph, ml/m
increase the flow, or the
rev. 2.1
Operation
keys to set the new value. Press
Operation
keys at the same time to increase
keys to decrease it.
Display during Setting (MODE key)
Operating mode
Man (during manual modification of the
flow it displays the corresponding
frequency value)
MAN
Current dosage value
Modify the maximum flow by pressing the
+ or – keys at the same time
Operation
keys at the same time to
keys to decrease it.
key, then
to
P100%
3
Publicidad
