Philips HR1652 Manual De Instrucciones página 10

EnglisH
10
3 Connect the coupling unit to the motor unit ('click') (Fig. 9).
4 Put the plug in the wall socket and press the on/off button.
5 After approx. 1 minute, you can press the turbo button to continue at turbo speed.
Detaching the whisk
1 To detach the whisk, press the release button (Fig. 10).
2 To detach the coupling unit, pull it from the whisk (Fig. 11).
milk foamer (Hp1651 only)
1 Connect the milk foamer to the coupling unit ("click"). (Fig. 12)
2 Connect the coupling unit to the motor unit (Fig. 13).
3 Plug in the appliance.
4 Heat up the milk to a temperature between 55°C - 65°C/131°F - 149°F.
Tip: You will achieve the best results if you use long-life milk with 3.5% fat content.
Note: Do not heat up the milk to a temperature beyond 65°C/149°F. Never let the milk boil.
Do not process more than 1 batch without interruption. Let the appliance cool down for 5
minutes before you continue processing.
5 Pour the milk into a tall heat-resistant beaker.
6 Set the speed ring to the highest setting, press the ON/OFF button and froth the milk for
approximately 60 seconds.
Note: Clean the milk foamer immediately after use (see chapter 'Cleaning' and the cleaning table).
Detaching the milk foamer
1 To detach the coupling unit, press the release button (Fig. 14).
2 To detach the milk foamer, pull it off the coupling unit (Fig. 15).
3 To detach the milk foamer cones, pull them off the milk foamer (Fig. 16).
cleaning (Fig. 17)
Do not immerse the motor unit, the coupling units or the medium chopper lid (HR1652 only) in
water, nor rinse it under the tap. Use a moist cloth to clean them (Fig. 18).
1 Unplug the appliance.
2 Press the release button on the motor unit to remove the accessory you have used.
3 Disassemble the accessory.
Tip: You can also remove the rubber ring from the chopper bowl for extra thorough cleaning.
4 See the cleaning table for further instructions.
Tip: For quick cleaning of the blender bar, pour warm water with some washing-up liquid into the beaker,
insert the blender bar and let the appliance operate for approx. 10 seconds.