Bestway 58486 Manual De Instrucciones página 7

ASSEMBLY
1. Carefully remove all components from
the package and check to ensure
nothing is damaged. If equipment is
damaged, immediately notify the
retailer from where the equipment was
purchased.
2. The sand filter should be placed on
solid, level ground, preferably a concrete slab. Position
the sand filter so the Ports and Control Valve are
accessible for operation, servicing and winterizing.
3. EN60335-2-41 TEST standard requires the sand filter
to be vertically fixed on ground or a certain pedestal
made of wood or concrete before use to prevent the
sand filter from accideutally falling. Fully assembled
sand filter will exceed 18 kg. The mounting holes
should be 8 mm in diameter and spaced 86 mm apart.
Use two bolts and nuts with a maximum of 8 mm in
diameter to fasten the sand filter to the pedestal.
LOAD POOL-GRADE FILTER SAND/FLOWCLEAR™ POLYSPHERE.
NOTE: Use only special pool-grade filter sand, free of all
limestone or clay: #20 Silica sand 0.45-0.85 mm,
approximately one 36 kg bag should suffice.
If you do not use the recommended size of filter sand, filtering
performance will be reduced and thesand filter may
damaged, thereby voiding the warranty.
NOTE: To avoid damaging the Skimmer when adding sand,
pour some water into the Bottom Tank to submerse the
Skimmer on the Hub.
NOTE: Sand/Flowclear™ Polysphere not included.
NOTE: Use 28 g (0.06 lbs) Flowclear™ Polysphere to replace
1 kg (2.20 lbs) sand.
(You will need a screwdriver.)
7
86 mm
Ф8 mm