How To Operate; Part Description; Final Assembly - Princess 352600 Instrucciones De Uso

HOW TO OPERATE :

Control panel with off button and 3 speed buttons (9)
0 Switches the motor off
1,2,3 3 different fan speeds; 1 = low, 2 = medium, 3 = high
Knob for automatic swivelling on/off (6)
Pull up: automatic swivelling is switched off.
Press down: switches swivelling on.
Pre-determined settings for fan tilting (8)
The fan can be tilted by hand up or down in a certain amount of pre-determined positions. Just push the
fan guard up or down and it will hinge around the Hinge point.
Height adjustment (12)
The height can be adjusted by loosening the knob on the stand. Once the correct height has been set
tighten the knob again.

PART DESCRIPTION :

1. Front guard
2. Blade lock nut
3. Fan blade
4. Guard lock nut
5. Rear guard
6. Swivel on/off knob
7. Motor
8. Tilt hinge point
9. Body with control panel
10. Body fixture screw
11. Inner tube
12. Height adjustment knob
13. Stand
14. Base cap
15. Screw
16. Base
ASSEMBLING THE FAN ONTO THE BODY
1. Remove the Blade lock nut from the shaft of the Motor.
2. Remove the Guard lock nut. Position the Rear guard onto the Motor making sure that the pins on the
Motor match with the holes on the Rear guard. Fix the Rear guard by screwing the Guard lock nut back
on tightly.
3. Insert the Fan Blade onto the shaft of the Motor. Be sure that the pin on the shaft is positioned inside
the slot on the Fan blade.
4. Screw the Blade lock nut onto the Motor shaft to make sure the Fan blade is tightly fixed.
5. Mount the Front guard to the Rear guard together with the Plastic ring.
6. Tighten the screw in the Plastic ring.
ASSEMBLING THE BASE AND STAND
7. Remove the screws from the Base and install the Stand onto the Base with these screws.
Remove the Height adjustment knob, so that the Base cap can slide over the Stand and
can cover the screws. Place the Height adjustment knob back again.
8. Pull up the Inner tube and hold the tube tight while you tighten firmly the Height adjustment
knob.

FINAL ASSEMBLY

Mount the Fan with Body onto the Inner pipe of the Stand and hold the Body while you fix
firmly the Body fixture screw.
2
4
3
1
5
9
15
16
6
7
8
10
11
12
13
14
6