Start-Up; Inserting/Changing Batteries; Setting The Scales - ADE BE 1806 Instrucciones De Operación

Start-up

Inserting/changing batteries

To use the scales, you require 2 batteries of the type CR2032, 3V (included in scope of
delivery). The battery compartment is located on the underside of the device.
1. Press the locking tab towards the middle of the scales and remove the battery
compartment cover, which is labelled with OPEN.
2. Push the batteries against the contact springs under the large, angular retaining
tabs. The batteries then snap into the opposite retaining collars, such that the
batteries sit firmly in their retainers.
Pay attention to the correct polarity (+/-). The plus pole (+) for both batteries must
point upwards.
3. Put the battery compartment cover back in place. The locking tab must snap
securely into place.
Notes on changing the battery:
‚ A change of batteries becomes necessary when "LO" appears on the
display, or when nothing at all is displayed.
‚ Only use the type of battery that is specified in the "Technical Data".
‚ Always change both batteries at the same time.
‚ Dispose of batteries in an environmentally appropriate way (see
"Disposal")
‚ Calibrate the scale, see "Setting the scale".
Choosing the unit of measurement
When the scales are delivered, the unit of measurement is set to "kg" as standard.
However, the measurement result can also be displayed in the English units of
measurement, "lb" (pound) or "st:lb" (stone:pound).
− Press the UNIT button next to the battery compartment on the rear-side of the
scales repeatedly. Pay attention to the display indicator.

Setting the scales

1. Place the scale on an even, firm, and dry surface. Do not place the scale on carpet.
2. First, briefly step onto the middle of the weighing surface to calibrate the scale. As
soon as the display shows "0.0", calibration is complete.
This calibration must be performed after each battery change.
Bathroom Scale BE 1806 | 1807
Start-up
17