Schumacher Electric PBI1812 El Manual Del Propietario página 7

11. TROUBLESHOOTING
PROBLEM
The booster won't jump
start my car.
The booster won't power
my 12V device.
The battery in the booster
won't hold a charge.
12. SPECIFICATIONS
V
12V
AGM
TEST
POSSIBLE CAUSE
Clips are not making a good
connection to the battery.
The booster battery is not
charged.
The vehicle's battery is
defective.
The fuse has blown.
The 12V device is not
turned on.
The booster battery is not
charged.
The 12V device draws more
than 15A or has a short circuit
The battery is bad (will not
accept a charge).
START
PEAK
1V/C
BATTERY
410 2200
CHARGE
CHARGER
Input:100-240V ~ 50/60Hz
Output:17V 0.7A
CABLE LENGTH
GAUGE
28 in./0.71 m
4G
PROTECTION
< 250
MAX HP
7
REASON/SOLUTION
Check for poor connection to
battery and frame. Make sure
connection points are clean.
Rock clips back and forth for a
better connection.
Check the battery charge status
by pressing the button on the
front of the booster. See LED
Indicators section of this manual.
Have the battery checked.
Replace the fuse.
(See Section 8.)
Turn on the 12V device.
Check the battery charge status
by pressing the button on the
front of the booster. See LED
Indicators section of this manual.
Disconnect the 12V device.
The internal breaker will
automatically reset after a
minute or two. Try the 12V
device again. If it happens
again, replace the 12V device.
Have the battery checked.
278.9 x 95 x 317
POWER OUT
MEMORY
15A FUSE
7.22