Safety Precautions; Service And Support - Danfoss VLT OneGearDrive Serie Guia De Instalacion

Safety Warnings
1 1
corresponding work, and qualified personnel are obliged to
abide by the instructions contained therein. Qualified
personnel are persons who are authorized due to training,
experience, and instruction as well as their knowledge of
relevant standards, rules, accident-prevention regulations,
and operating conditions. The person responsible for the
safety of the installation must perform the activities
required in each case and be able to recognize and avoid
potential hazards.
Knowledge of first-aid measures and of the available life-
saving equipment is also required.
Unqualified personnel are forbidden to work on the VLT
OneGearDrive.

1.6 Safety Precautions

WARNING
HIGH VOLTAGE
High voltage, which can lead to death or serious injury,
is present on the connectors.
•
Before working on the power connectors
(disconnecting or connecting the cable to the
®
VLT
supply to the frequency converter and wait for
the discharge time to elapse (see the frequency
converter operating guide).
•
Installation, start-up, maintenance, and
decommissioning must only be performed by
qualified personnel.
CAUTION
DANGER OF BURNS
The surface of the OneGearDrive and the oil in the
OneGearDrive can reach high temperatures during
operation.
•
Do not touch the OneGearDrive until it has
cooled down.
•
Do not carry out an oil change until the oil has
cooled down sufficiently.

1.7 Service and Support

Contact the local service representative for service and
support:
vlt-drives.danfoss.com/Support/Service/
4
OneGearDrive), disconnect the power
Danfoss A/S © 07/2017 All rights reserved.
®
M0021001