Astralpool 18543 Manual De Instalación página 2

CHECK THE CONTENTS
Check that the components of the chosen model are in
good condition.
INSTALLATION
1. Choose a suitable position bearing in mind the following:
•
The measurements of the slide (see attached dia-
gram).
•
The minimum safety levels recommended.
•
Ensure that the water flowing down the slide ram will
fall inside the pool.
•
There must be a water supply inlet at the foot of the
ladder, to connect with the nozzle, which will supply
water to the slide ramp, with a valve under a cover
that can only be opened using a tool.
2. To anchor the slide firmly to the ground, a concrete area
should be made as a foundation measuring 1m x 0.5 m
and 0.3 m., both at the foot of the ladder and at the
front support of the slide ramp.
3. Assemble the handrails of the slide separately inserting
them in the slide ramp (first the upper part and then
placing them in the lower housing).
4. Assemble the steps, which will join the two handrails.
5. Once the concrete has set, place the slide in position
and mark the fastening points on the ground.
6. Remove the slide and drill the previously marked points
on the cement, using a 10mm. drill bit.
7. Firmly anchor the slide to the ground with the screws,
plugs and washers provided.
8. Connect the nozzle of the slide ramp to the water supply
inlet with the transparent hose provided.
Once you have assembled the slide, keep this manual
in a safe place in case you need a spare part in the
future.
This product is manufactured in accordance with standard UNE-EN 1176.3
INSTALLATION MANUAL OF PUBLIC SLIDE CODE:
Read this manual carefully before assembling the slide
* * *
POS. CODE
1 18543-0200
1 18545-0200
2 18543-0100
MAINTENANCE
Regularly check the following:
1. The good condition of the slide ramp nozzle, ensuring that
it is not blocked or broken and that water flows properly.
This will prevent the slide ramp from overheating from the
sunrays and will help users to slide down the ramp.
2. Ensure that the transparent hose through which water
flows to the slide ramp nozzle, is in good condition.
3. Ensure that the slip-proof bands on the steps are in good
condition, and replace them immediately when they are
worn.
4. Ensure that the black outline of the edges is in good con-
dition. If it becomes detached, stick it down with
cyanoacrylate adhesive.
placed as it protects users from injury.
5. Check that the polyester surface is not cracked or dented
as they could cause cuts and grazes to users. Clean the
slide with detergent containing disinfectant and lime des-
caler, making sure that it does not drip into the pool.
SAFETY WARNINGS
Do not delay repairing or replacing a damaged part which
may cause accidents.
Follow the regulations of each country regarding the position
of the slide and safety levels.
Bear in mind that the length * must project out of the wall of
the pool as much as possible, for greater safety.
RECOMMENDATIONS TO AVOID ACCIDENTS
Check that there are no bathers in the safety area before us-
ing the slide.
Users should slide down one by one and not pile up under the
ramp.
This slide is designed to support the weight of adults.
Slide down the ramp in the normal position.
* * *
DESCRIPTION
STRAIGHT SLIDE RAMP
LEFT CURVED SLIDE RAMP
SLIDE HAND RAIL
If it is worn, it should be re-
18543E200
18543
18545