Westinghouse LED 43T8 Manual Del Usuario página 4

WARNING :
Warning: Risk of fire or electric shock. LED retro t kit installation requires knowledge of luminaires electrical
systems. IF not qualifed, do not attempt installation. Contact quali ed electrician.
Warning: Risk of fire or electric shock. Install this kit only in the luminaires that have the construction features
and dimensions shown in the photographs and/or drawings and where the input rating of the retro t kit does
not exceed the input rating of the luminaire.
Do not make or alter any open holes in an enclosure of wiring or electrical components during kit installation.
WARNING- To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or other sharp
objects.
Installers should not disconnect existing wires from the lamp holder terminals to make new connections at lamp
holder terminals. Instead installers should cut existing lamp holder leads away from the lamp holder and make
new electrical connections to lamp holder lead wires by employing applicable connectorsmarking for the lamps
with which the ballast is intended to be used, for example F40T12/IS. For more information, contact the LED
luminaire retro t kit manufacturer.
THE RETROFIT ASSEMBLY IS ACCEPTED AS A COMPONENTOF A LUMINAIRE WHEN THE SUITABILITY OF THE
COMBINATION SHALL BE DETERMINED BY UL OR AUTHORITES HAVE JURISDICTION.
The units covered by this report were intended to retro t surface mount with di user for these models, Type IC or
non-IC recessed mount listed uorescent luminaires that use maximum 2 tubular lamps, the minimum lamp
compartment dimensions are tabulated below:
MODEL NUMBER
LED 43T8/96"/XX Ballast Bypass
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
The luminaire wiring has now been modified and will no longer operate fluorescent lamps.
This device is not intended for use with emergency exits.
MINIMUM COMPARTMENT DIMENSIONS
[Length x Width x Height] [cm]/[in]
244 x 27 x 7 / 90.06 x 10.63 x 2.76
Do not use with dimmers.
Suitable for damp locations.
4
LAMP
QUANTITY
2
ESF-WH-024