Accessories And Replacement Parts - Bolens BL410 Manual Del Operador

MAINTENANCE & REPAIR INSTRUCTIONS
0.020 in.
(0.5 mm)
4. Install a correctly gapped spark plug in the cylinder head.
Tighten by turning the 5/8 in. socket clockwise until snug.
If using a torque wrench torque to:
110-120 in.•lb. (12.3-13.5 N•m)
Do not over tighten.
CLEANING THE UNIT
WARNING: To avoid serious personal injury,
always turn the off and allow it to cool before
you clean or service it.
• Use a small brush to clean off the outside of the unit and
to keep the air vents free of obstructions.
• Do not use strong detergents or petroleum based
cleaners, like kerosene. Some household cleaners
contain aromatic oils such as pine and lemon that can
damage the plastic housings or handles. Wipe off any
moisture with a soft cloth.
STORAGE
• Never store a fueled unit where fumes may reach an
open flame or spark.
• Allow the engine to cool before storing.
• Store the unit in a locked up area to prevent
unauthorized use or damage.
• Store the unit in a dry, well-ventilated area.
• Store the unit out of the reach of children.
LONG TERM STORAGE
If you plan to store the unit for an extended time:
1. Drain all fuel from the fuel tank into a container. Do not
use fuel that has been stored for more than 60 days.
Dispose of the old fuel in accordance to local regulations.
2. Start the engine and allow it to run until it stalls. This
ensures that all fuel has been drained from the carburetor.
3. Allow the engine to cool. Remove the spark plug and put
1 oz. (30 ml) of high quality motor oil into the cylinder.
Pull the starter rope slowly to distribute the oil. Reinstall
the spark plug.
NOTE: Remove the spark plug and drain all of the oil
from the cylinder before attempting to start the
unit after storage.
4. Thoroughly clean the unit and inspect for any loose or
damaged parts. Repair or replace damaged parts and
tighten loose screws, nuts or bolts. The unit is ready for
storage.
TRANSPORTING
Fig. 19
• Allow the engine to cool before transporting.
• Secure the unit while transporting.
• Drain the fuel tank before transporting.
• Tighten fuel cap before transporting.
MOVING THE UNIT
1. Allow the unit to cool before moving.
2. Loosen the knobs on the handlebar.
3. Fold the handlebars down as shown (Fig. 20).
4. Either carry the unit by the shaft tube grip or grasp the
center of the handlebar to use it as a carrying handle
(Fig. 21).
5. After the unit has been moved, reposition the
handlebars and continue operation.
ACCESSORIES/REPLACEMENT PARTS
2-Cycle Oil . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 147543
Spark Plug . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 610311
Fuel Cap . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 180000
Tine ( L ) (Left Side Outer or Right Side Inner) . . . . . . . . .182729
Tine ( R ) (Right Side Outer or Left Side Inner) . . . . . . . . .182730
Clevis Pin with Clip . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .147473
14
Handlebar Knobs
Shaft Tube
Grip
Fig. 20
Fig. 21