Programming Device Codes; Entering The Device Code According To The Code List - Medion MD 81035 Manual De Usuario

Keypad backlight: Press the key
backlighting on or off. – Please note that the keypad back
lighting is only visible in a dark environment.

Programming device codes

General
For every device that you would like to operate using the uni
versal remote control, you must program a three digit de
vice code to a source key (TV, VCR, DVD, ASAT, DSAT,
CBL, CD, AUX) . You can assign any key to any device
("Flex Mode"), with exception of the TV key which can only
be assigned to a TV.
Combined devices (e.g. TV set with video recorder): It is
often necessary to assign two source keys with the respec
tive code for each part of the device. However, there are also
combined devices with only one code for both device parts
(see also "Operating combined devices", page 7).
VCR's: The code search for VCR's must be done while a
tape is inserted.
Pre programming
The remote control has been pre programmed for several
devices produced by Medion. Because of this you can use
certain basic functions for, for example, a Medion television
directly and without having to programme in the device
code.
Entering the device code according to the
Code List
The codes of the corresponding devices can be found in the
Code List enclosed with these operating instructions. Pro
ceed as follows:
1. Switch the relevant device on manually.
2. Keep the SETUP key pressed down for approx. 3
seconds, the background lighting of the source key will
flash for a short time and then remain permanently lit.
(Briefly pressing the SETUP key will activate the SHIFT
function.)
3. Briefly press the desired source key (TV, VCR, DVD,
ASAT, DSAT, CBL, CD, AUX).
4. Enter the three digit code from the Code Table.
The background lighting will extinguish briefly each
time the key is pressed.
If the entered code was valid, the light of the source
key will extinguish after the last digit has been en
tered. If an invalid code was entered, the source key
will flash for three seconds before extinguishing.
If the device does not respond as expected, repeat the pro
gramming, or try a different code. Please try all the codes
specified for your brand. Select the code that causes all the
available commands of your remote control to respond cor
rectly.
If this is not successful either, then try using the search me
thod described in the chapter "Automatic Search".
1. Only the source key that was actuated last will light
up. During first use, the TV key will light up.
to turn the keypad
4
1