Description Of The Hood & Controls; Controls; Description Of Control Panel - ELICA Samurai Guía De Instalación, Uso Y Mantenimiento

Description of the hood &

Controls

1 Control panel
2 Grease filter (Number of filters may vary)
3 Grease filter release handle
4 Halogen lamp (Position and number of lamps may vary)
5 Hood canopy
6 Duct cover
7 Louver holes (Ductless configuration)
Controls
Use the high suction speed in cases of concentrated kitchen
vapours. It is recommended that the cooker hood suction is
switched on for 5 minutes prior to cooking and to leave in
operation during cooking and for another 15 minutes
approximately after terminating cooking.
Note: Hood retains last speed setting when aspiration
switch is turned off.

Description of control panel

Description of control ball and hood operation
The control ball is equipped with a motor status light.
• No signal light:
The hood is switched (Off).
• Static green light :
Hood is switched (On) at power level 1 (Minimum).
• Static orange light :
Hood is switched (On) at power level 2 (Medium).
• Static red light :
Hood is switched (On) at power level 3 (Maximum).
• Flashing red light :
Hood is switched (On) boost speed (Timed at 5 minutes,
then returns to static red light)
• Flashing green light :
Indicates the grease filter saturation - clean the grease
filter
• Flashing orange light :
Indicates the charcoal filter saturation - clean or replace
the charcoal filter.
Attention!
The control ball flashes orange to indicate the saturation
of the charcoal filter even if the hood is used in the
extraction mode and no charcoal filter is fitted.
In this case, perform the signal reset operation as
follows: Select the boost speed (the control ball lights up
with a red flashing light), press again and hold pressed
for 3-5 seconds until a beep signal indicates the reset
has taken place.
Reset filter saturation signal
Green or orange flashing light
Proceed as follows:
Select the boost speed (The control ball switches on with
flashing red light), depress again and hold for 3-5 seconds
until the beep signal indicating that reset has occurred.
Switching on the cooker hood
The control ball is a balance wheel switch.
Depressing the control ball towards the right repeatedly
switches on the cooker hood and all the suction speed
selections up to the boost mode, depressing again towards
the right the cooker hood switches off.
Turning on the light
Depress the control ball towards the left:
Once for dim lighting,
Pressing again for full lighting,
Pressing again switches the light (Off).
11