LAZBOY Duo Instrucciones De Operación página 6

duo Sofa, Sectional, Loveseat & Chair
TM
ssembly Instructions
WARNING
– To reduce the risk of serious injury:
• Provide a clear path for operation of the legrest. Place tables at a distance to allow
the legrest to fully extend without rubbing or interference.
6. If using the 9-volt battery backup feature, proceed to the Battery Backup Assembly Instructions
on page 12, then continue with assembly Step 7 below.
7. Each reclining seat has its own motor and uses its own power supply. Locate the motor connector
behind the reclining seat (F 14).
IGURE
8. Make the power supply connections.
Remove power supply and 120 volt power cord from box and unwind cord.
•
Connect the 120 volt power cord to the power supply. Align the 120 volt power cord connector to the
•
power supply and push together until fully seated (F
Connect the motor connector to the power supply. Align the motor connector to the power supply and
•
push together until fully seated (F
IGURE
Place the power supply on the shelf, making sure not to pinch any cords (F
•
Repeat these steps for each power supply included with the unit. Return unit to its upright position.
•
If you are assembling a sofa or chair, proceed to the Operating Instructions. Do not plug in until
•
instructed in the Operating Instructions.
9. Join sectional units. Sectional units use a single bracket system to join the pieces together;
the bracket system is not intended to be weight-bearing. The joining bracket is positioned in the
up (or "receiving") direction when mounted on the right (as sitting) side of a unit, and in the
down, or "engaging", direction when mounted on the left (as sitting) side of a unit (F
Take note of the bracket direction on each unit that you are joining.
•
• Align the units to be joined next to each other and align the mating brackets.
• Starting with either the right or left arm unit and the unit next to it, slightly spread the front corners of
the two units, enough to view the joining brackets.
Lift the front corner of the unit with the bracket facing down, in the "engaging" position, approximately
•
1" – 2" above the adjoining unit, move the unit over to close the front gap and gently lower into place,
making sure the two brackets are engaged.
Repeat these steps until all units are joined.
•
10. All sectional units must be disconnected to safely move the units. Reverse Step 9 to disconnect
the units.
NOTICE:
To reduce the risk of product damage - -
• Do not move the units while connected together. The purpose of the bracket system is
to connect the units and prevent them from being separated while on the floor. The
bracket system does not provide adequate structural support for the movement of
connected units.
11. Proceed to the Operating Instructions. Do not plug in until instructed in the Operating Instructions.
10
15).
IGURE
16).
17).
IGURE
IGURES
duo
F 14
IGURE
F 16
IGURE
18 and 19).
Connect Motor Connector to Power Supply
F 18
IGURE
Joining Bracket
Positioned Facing Up on
Right (as sitting) Side
Sofa, Sectional, Loveseat & Chair
TM
ssembly Instructions
F
IGURE
Motor Connector Connect 120 Volt Power Cord to Power Supply
F
IGURE
Place Power Supply on Shelf
F
IGURE
15
17
19
Joining Bracket
Positioned Facing
Down on Left
(as sitting) Side
Lift UP on This Side
11