Power Input - Analog way iX Mate XM513 Manual De Usuario

Chapter 1 : INTRODUCTION (continued)
1-4. FRONT PANEL DESCRIPTION
SIGNAL OUTPUT LOAD
IN 1
POWER
POWER:
SIGNAL IN:
OUTPUT LOAD 1,2,3:
1-5. REAR PANEL DESCRIPTION
MODEL: XM513

POWER INPUT:

O / I:
DVI-D:
ANALOG:
SD-HD SDI:
PAGE 6
SIGNAL
OUTPUT LOAD SIGNAL OUTPUT LOAD
IN 2 3 IN 1
2 3 1
Power ON LED indicator.
Input signal detected LED indicator for each input.
NOTE: -For the SD/HD-SDI inputs: the LED turns ON when a signal is detected onto the
input BNC connector.
-For the ANALOG inputs: the LED turns ON when a ground signal is detected
onto the pin #10 of the HD15 input connector. The LED may stands OFF if you
connect a C.VIDEO, S.VIDEO, YUV/RGB signal.
-For the DVI input: The LED turns ON if the input source comes directly from a
graphic board and if a display device is connected to the DVI OUT1/MONITOR
connector.
Output load LED indicator for each output.
NOTE: -For the SD/HD-SDI outputs: the LED turns ON when a 75Ω load is detected onto
the output BNC connector.
-For the ANALOG outputs: the LED turns ON when a ground signal is detected
onto the pin #10 of the HD15 output connector. The LED may stands OFF if you
connect a C.VIDEO, S.VIDEO, YUV/RGB display.
-For the DVI outputs: The LED turns ON when a display device is connected to
the output DVI connector.
ANALOG # 2
DVI-D
Standard IEC connector (100-250 VAC, 50-60 Hz, Automatic).
AC Power Switch (O=OFF, I=ON).
IN: DVI-D input (DVI-I female connector).
OUT1/MONITOR: Monitoring output (DVI-I female connector).
OUT 2 & OUT 3: Splitted outputs (DVI-I female connectors).
NOTE: The DVI channel is not compatible with HDCP; it may not work if you
connect a HDMI source.
IN: Analog input (HD15 female connector).
OUT1/MONITOR: Monitoring output (HD15 female connector).
OUT 2 & OUT 3: Splitted outputs (HD15 female connectors).
IN: SD/HD-SDI input (BNC female connector).
OUT1, OUT 2 & OUT 3: Splitted outputs (BNC female connectors).
SIGNAL OUTPUT LOAD SIGNAL OUTPUT LOAD
2 3
IN 1 2 3 IN 1 2 3
IN
iX Mate™