Returning For Service - DeFelsko PosiTector DPM L Guia De Incio Rapido

Returning for Service

For issues related to the PosiTector DPM L probes:
1. Install new batteries in the proper alignment with positive
side up.
2. Examine the sensor for debris or damage.
3. Re-attempt measurement.
For Issues related to the PosiTector Advanced Gage Body:
1. Perform a Hard Reset as follows:
A. Power down the Gage and wait 5 seconds.
B. Simultaneously press and hold the (+) and center buttons
until the Reset symbol
This returns the Gage to a known, "out-of-the-box" condition.
WARNING:
All readings in memory will be erased.
2. Update your PosiTector gage body and re-attempt
measurements.
If these steps do not resolve the issue, visit our Service &
Support page for information on sending your Gage to us for a no
charge evaluation. See: www.defelsko.com/service
For issues related to the PosiTector App, please refer to the
Help File located at: www.defelsko.com/app-help
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
appears.
12