Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
•
Setting Re ected Temperature Compensation
To enable and set re ected temperature compensation, use the main program menu
to select:
[Setup]
Re ected temperature compensation can be enabled/disabled using [Compensate
for Re ected Temperature], and when enabled the temperature value can be set
between -40 and 1000°C.
OPERATION
Once the sensor is in position and the appropriate power, air, water, and cable con
nections are secure, the system is ready for continuous operation by completing the
following simple steps:
1. Turn on the power supply
2. Turn on the instrument or PC
3. Read / monitor the temperature
IMPORTANT
Be aware of the following when using the sensor:
• If the sensor is exposed to signi cant changes in ambient temperature (hot to cold,
r o
c
o
d l
o t
h
recording measurements.
• Do not operate the sensor near large electromagnetic elds (e.g. around arc welders
or induction heaters).
Electromagnetic interference can cause measurement errors.
• Wire must be connected only to the appropriate terminals.
M AINTENANCE
Our customer service representatives are available for application assistance, calibra
tion, repair, and solutions to speci c problems. Contact our Service Department before
returning any equipment. In many cases, problems can be solved over the telephone.
If the sensor is not performing as it should, try to match the symptom below to the
problem. If the table does not help, call PCE Instruments for further advice.
TROUBLESHOOTIN
S ymptom
No output
Erroneous temperature
Erroneous temperature
Erroneous temperature
L ENS C LEANIN G
Keep the lens clean at all times. Any foreign matter on the lens would a ect measure
ment accuracy. Blow o loose particles (if not using the air purge accessory) with an
air 'pu er'.
GUARANTEE
PCE guarantees each instrument it manufactures to be free from defect in material
and workmanship under normal use and service for the period of two years from the
date of purchase. This guarantee extends only to the original buyer according to PCE
Instruments Terms and Conditions of Sale.
›
8
[Re ection Compensation]
o
, ) t
a
o l l
w
2
0
m
n i
t u
G
P robable C ause
No power to sensor
Incorrect wire connection
Faulty sensor cable
Field of view obstruction
s e
o f
t r
e h
e t
m
p
e
a r
u t
e r
o t
s
a t
b
i l i
e s
b
e
S olution
Check power supply
Check wire colour codes
Verify cable continuity
Remove obstruction
-
o f
e r
t
k a
n i
g
r o
-
-
Publicidad
Tabla de contenido
