Maintenance Instructions - Desoutter B Serie Manual Del Usuario

English
LUBRICATION
This tool is fitted with blades which can
operate without lubricated air. However,
a small amount of oil allows the tool to
provide full power and lengthens its life.
The use of dry air with no trace of oil may
reduce the life of blades.

MAINTENANCE INSTRUCTIONS

The use of spare parts other than those
originally supplied by the manufacturer
may result in a drop in performance or
in increased maintenance and level of
vibration and in the full cancellation of the
manufacturer's liability.
To obtain maximum efficiency from the
pneumatic tool, preserve its features
and avoid repeated repairs, a routine
inspection and repair programme
are recommended at least every 500
operating hours or every 6 months as a
minimum. In heavy-duty conditions, the
inspection program can be performed
every 3 months.
● Disassemble the tool, clean and
check the parts carefully.
● Check the condition of the bearings
and inspect the vanes for wear and
surface condition.
When disposing of components,
lubricants, etc... ensure that the relevant
safety procedures are carried out.
01/2015
DISASSEMBLY AND REASSEMBLY
INSTRUCTIONS
See page 4.
Disconnect the machine from the
compressed air supply.
Remove all accessories.
● Before disassembling the machine,
decompress the air from the oil tank by
loosening and retightening the screw (22).
● At each disassembly of the governor, clean
the spring housing, check the condition of the
spring and re-lubricate it carefully.
The governor has a calibrated spring
which can only be replaced by an original
spare part.
● When re-assembling, always position the
cylinder exhaust on the opposite side of the
turbine housing.
11 / 40
6159945750_06
Indicates direction of dismantling.
Series: B