Installing And Charging Batteries - GAVASA SLD-300 Manual Del Usuario

Parts diagram:

3. INSTALLING AND CHARGING BATTERIES

Take out the battery pack and insert it to the detector's battery compartment, noting the correct orientation.
Charging batteries
Under the status of power off:
Once the battery pack has been installed, plug the battery charger into a wall outlet and connect the charger jack to
the unit (see Fig 3). When it is correctly connected, the first LED will indicate charging status:
Flashing blue = battery charging
Constant blue = battery fully charged
TIP: if it is charged under the status of power off, the leak detector will not be started.
Under the status of power on:
Plug in the charger, seven blue LED indicator lights will be on one by one in circulation during the process of
charging.
When fully charged, the seven blue LED indicator lights will be constant on.
Note: It is suggested to charge batteries when the detector is turned off.
New or completely discharged batteries will take approximately six hours to be fully charged. When the LED
indicates that the batteries are fully charged, plug off the charger, and the unit is ready for operation
10
CATÁLOGO TÉCNICO
MANUALES, CATÁLOGOS Y HOJAS TÉCNICAS: EN NUESTRA WEB
1. On / Off key
2. Sensitivity high / low key
3. Reset key
4. Alarm key
5. Battery voltage indicator (1st LED)
6. Visual leak size indicators (1st-7th LEDs)
7. Sensor
8. Flexible probe
9. Charger input jack
10. Li-lion Battery pack
(see Fig 2)
to prevent personal injury, do not use this leak
Warning:
detector in an explosive or combustible atmosphere.
Ambient atmosphere is drawn through the probe and
sensor, which operate at a very high temperature.
The resulting hot mixture of air and combustible gas could
explode.
Caution: to prevent equipment damage, charge batteries
only in temperatures between 10°C and 40°C.
Charging batteries outside this temperature range may
cause permanent damage to the batteries.
SLD-300 LEAK DETECTOR OWNER'S MANUAL