Turn power switch to "OFF" (O) and always remove plug from the wall outlet before troubleshooting. Trouble
WARNING
!
shooting should be performed with a pin-end blade if available.
TROUBLE
Breaking blades.
Motor will not run.
Vibration
NOTE: There will always
be some vibration present
when the saw is running
because of motor
operation.
Troubleshooting
PROBLEM
1. Wrong tension.
2. Over working blade.
3. Wrong blade application.
4. Twisting blade in wood.
5. Incorrect teeth per inch.
1. Defective cord or plug.
2. Defective motor.
3. Defective wire connections.
4. Brushes worn.
1. Improper mounting of saw.
2. Unsuitable mounting surface.
3. Loose table or table resting
against motor.
REMEDY
1. Adjust blade tension, see REMOVING AND
INSTALLING BLADES, Pages 11 & 12.
(Pin End) or (Plain End).
2. Reduce feed rate, see BASIC ScrollStation OPERA-
TION, Page 11.
3. Use narrow blades for cutting thin wood, wide blades
for thicker wood.
4. Avoid side pressure on blade - avoid over-tensioning
pin-end blade.
5. Blade should have minimum 3 teeth in contact with
workpiece.
1. Replace defective parts before using saw
again.
2. & 3. Consult Dremel Service. Any attempt to
repair this motor may create a HAZARD
unless repair is done by a qualified service
technician.
4. Replace both brushes.
1. See MOUNTING YOUR ScrollStation,
Pages 10.
2. The heavier your work bench is, the less vibration will
occur. A plywood workbench will not be as good a
work surface as the same size solid lumber. Use
common sense in choosing a mounting surface.
3. Tighten table wing knob.
16