Bosch PAM 220 Manual Original página 26

26 | English
"Normal Measuring Mode"
After switching on, the measuring tool is always in normal measuring
mode.
Measuring Angles (see figures C–E)
Place the fold-out leg 1 and the base leg 3 flat on the surfaces adjacent to
the angle. The displayed measuring value a corresponds with the interior
angle w between the base leg and the fold-out leg.
This measured value is shown on the display 4 until you change the angle
between fold-out leg 1 and base leg 3.
Transferring Angles (see figure C)
Measure the angle to be transferred by appyling the base leg and the fold-
out leg to the reference angle.
Place the measuring tool in the desired position against the workpiece. Use
the legs as a straight edge to transfer the angle.
Ensure that the fold-out and base legs are not moved during transfer.
Marking Angles (see figure D)
Open the fold-out leg and the base leg until the required angle is indicated
in the display a.
Place the measuring tool in the desired position against the workpiece. Use
the legs as a straight edge to transfer the angle.
Storing the Measured Value ("Hold/Clear")
To store the current measured value ("Hold"), press the "Hold/Clear"
memory button 9.
The measured value is displayed until you press the "Hold/Clear" memory
button 9 again, regardless of any movements of the base and fold-out legs.
Measuring with Leg Extension (see figures F–H)
The leg extension 2 makes it possible to measure angles when the contact
surface is shorter than the fold-out leg 1.
Mount the leg extension 2 (see "Mounting the Leg Extension", page 25).
Place the base leg 3 and the leg extension flat on the surfaces adjacent to
the angle.
1 609 92A 0GC | (24.2.14) Bosch Power Tools