Philips HP3621 Manual Del Usuario página 10

ENGLISH
10
- For a cosmetic treatment, place the appliance on a table and sit down on a chair in front of the
appliance. Tilt the lamp housing backwards so that the beam of light is directed towards your
face (Fig. 11).
3 To adjust the direction of the light beam, tilt the lamp housing forwards or
backwards (Fig. 12).
4 Sit or lie down at the right distance from the appliance.
- At a distance of 25-30cm to the body, the InfraCare treats an area of about 30cm by 20cm
(w x h). At a larger distance, the area treated becomes larger and the infrared light and
therefore the heat less intense. At a smaller distance, the area treated is smaller and the infrared
light and therefore the heat more intense.
- Make sure the distance between your body and the appliance is large enough to prevent
accidental contact with the hot filter.
Choose a distance at which the heat is comfortable and increase the distance if
-
the heat becomes too intense.
Note: The heat of the appliance does not reach its full intensity until several minutes after you switch on
the appliance. This does not mean, however, that the appliance is not effective during these first minutes.
Duration of treatment
The duration of the treatment depends on the type of treatment and the person to be treated.
Treatment of a single muscle or joint should last approximately 15 minutes. If necessary,
the treatment can be repeated several times a day. A longer treatment time than 15 minutes does
not lead to better results. You can repeat the course of several treatments a day on several
consecutive days to get a result. If there is no improvement after 6-8 treatments, stop using the
appliance and consult your doctor. For chronic problems, the appliance can be used for longer
periods of time, as long as you follow the instructions given in the 'Warning' section in chapter
'Important'.
Using the InfraCare
1 Put the mains plug in the wall socket.
2 Press the on/off button to switch on the appliance.
3 After use, press the on/off button to switch off the appliance.
Cleaning
Unplug the appliance and let it cool down for about 15 minutes before you clean it.
Never use scouring pads, abrasive cleaning agents or aggressive liquids such as petrol or acetone
to clean the appliance.
1 Clean the lamp housing and the base with a moist cloth. Do not let any water run into the
appliance.
2 You can clean the outside of the filter with a soft cloth sprinkled with some methylated
spirits.
Storage
Do not let the mains cord come into contact with the filter when the filter is hot.
1 Unplug the appliance and let it cool down for about 15 minutes before you store it.
- Always lift or carry the appliance by its handgrip (Fig. 13).
2 Store the InfraCare in a dry place.