Aigostar 320100JVO Manual De Instrucciones página 11

1.Operating current not exceeding 30mA is advisable in the electrical circuit
supplying the bathroom. Ask your installer for advice.
CAUTION: If the electric cable is damaged, it must be replaced by the
manufacturer, his after-sales service or people with similar qualification, in
order to avoid any danger. In order to minimize the risks of electric shock,
In the event of breakdown, not to open the case but to call upon a
qualified technician for repairs.
Blade(FIG.C)
1. Your clippers were carefully examined to ensure that the blades were oiled
and aligned before leaving factory.
2. Blades must be realigned if they have been removed for cleaning or
replacement.
3. To realign the blades, simply match the station and moving blade teeth up,
point for point.
End of station blade teeth should be approximately 1.2mm back from
moving blades.
4. Compare your clipper blade with the sketch. If blade alignment is incorrect,
①Add a few drops of oil to the blades;
②Turn clipper on for a few moments, turn it off and unplug it;
③Loosen screws slightly and adjust;
④Tighten screws after blade is aligned.
Oil
1. To maintain your clipper in peak condition, the blades should be oiled
every few haircuts.
2. Do not use hair oil, grease, oil mixed with kerosene or any solvent.
Adjustable Lever(FIG.D)
1. The adjustable lever enables you to gradually change the closeness of your
cut without a comb attachment.
①A different cutting edge is used in each setting.
②Pushing the lever downward gradually increases the cutting length. In its
lowest position, the lever will leave the hair approximately the same
length as a #1 comb.
2. While the clipper is running, rapidly move the lever from "close cut" to
"longer cut" a couple of times. Doing this each time after you have
finished using your clipper will help to keep the blades clear of cut hair.
CLEANING
1.Before cleaning, switch the device off with the on/off switch. Always
GB
08