Compass Calibration - Bushnell BACKTRACK D-TOUR Manual De Instrucciones

MARKING/RETURNING to a LOCATION (cont.)
• You can use the five icons to mark five different
locations of any kind (your car, tent, scenic area, etc.).
Be sure you select a different icon to store each new
location. If you hold down MARK with a previously
used location icon still selected, you will replace that
one with your current location.
OTHER SCREENS
• Press POWER once again after the "Target" location
icon screen to view the temperature and altitude at
your current location (Fig. 6).
• Press POWER again to view the Compass screen,
displaying the Latitude and Longitude of your current
location, and a digital compass display including your
heading (direction of travel) in degrees (Fig. 7).
AUTO POWER OFF/BACKLIGHT
• Power automatically turns off after 10 minutes if no
buttons have been pressed (except in Trip mode,
described next). HOLD POWER to turn the unit off
manually.
• Press the MARK button to turn the display backlight
on. It automatically turns off after 30 seconds.

COMPASS CALIBRATION

• To ensure directional accuracy, hold the D-Tour out in
front of you and move it in a "Figure 8" pattern a few
times to re-calibrate the compass (Fig. 8). A compass
calibration video is available at: http://www.bushnell.
com/products/gps/instruction-videos/.
• For best results, we recommend holding the D-Tour
in a horizontal position (not tilted) during use (Fig. 9).
6
Fig. 6
8
Fig. 7
Fig. 8
Fig. 9