Getting Started; Inserting The Battery; Operational Summary - Bushnell Medalist 20-1354 Manual Del Usuario

Idiomas disponibles

GETTING STARTED

Lift the battery door tab and remove the battery door. Attach one 9-volt alkaline battery and replace the

battery door.

NOTE: Use only high quality alkaline batteries. Do not use heavy duty or lithium batteries. It is recommended

that the battery be replaced at least once every 12 months.

Low Battery Indicator (Lob): If the letters Lob appear, the battery charge is getting low and the 9-volt

alkaline battery should be replaced.

While looking through the 4x eyepiece, depress the power button once to activate the in-view Liquid

Crystal Display (LCD). Place the aiming circle (located in the center of the field of view) upon a target at

least 5 yards away, depress and hold the power button down until the range reading is displayed near

the bottom of the in-view display. Crosshairs surrounding the aiming circle indicate that the laser is

being transmitted. Once a range has been acquired, you can release the power button. The crosshairs

surrounding the aiming circle will disappear once the power button has been released (i.e. the laser is no

longer being transmitted). Note: Once activated, the LCD will remain active and display the last distance

measurement for 30 seconds. You can depress the power button again at any time to distance to a new

target. As with any laser device, it is not recommended to directly view the emissions for long periods of

time with magnified lenses. The maximum time the laser is transmitted (fired) is 10 seconds. To re-fire,

press the button down again.

Tabla de Contenido