Control Panel - SCHOLTES HLI 997 Instrucciones De Uso

Control panel

GB
ON (Stand by)/OFF: press the button for 3
seconds to obtain the ON (Stand by) condition; all the
buttons/commands are enabled.
ON/OFF lights
Adjusting suction power:
Press to increase or
the suction power. The
indicate that the hood is functioning. It switches off
when the hood returns to Standby (motor off).
NOTE: If the hood is not being used, we advise turning
it off by pressing the
illuminates the key will switch off).
Intensive suction power (timed)
Press this button to reach maximum suction power for
a period of 5 minutes (the
indicate that intensive suction power is functioning). At
the end the hood returns to the speed set previously.
To exit in advance from the function, press the same
key again.
Carbon filter saturation signal
This button lights up when maintenance of the carbon
filter is necessary.
To reset the signal, press the same button for a long
time (at least 3 seconds) until the confirmation beep is
heard.
This signal is normally off. Proceed as follows to
activate it:
With the hood in the off position, press the
First the lights up, after about a second the
button also lights up indicating that the carbon filter
saturation signal has been activated. Release the key.
If you want to deactivate the carbon filter saturation
signal previously set, repeat the operation:
First the two and
goes out, indicating the deactivation of the signal.
Grease filter saturation signal:
This key lights up when maintenance of the grease
filter is necessary. To reset the signal, press the same
button for at least 3 seconds until the confirmation
beep is heard.
20
to decrease and switch off
button switches on to
button twice (the LED that
button flashes to
button.
buttons light up: then the latter